Features
- Plastic molded.
- High reliability.
- Low cost.
- Test equipment: Q meter (HP 4342A)
- Measurement:
- Q and L measured with 1/2" long of TCW#16 soldered along the coil leads and with one end flush with the bottom of the coil then bent 1/4" down from stand off at an angle of 90 degree, except type 2901 with leads connected directly.
- L min. measured with core halfway out top of form, except type 2101, 2303, 2308 without core.
- Inductance greater then 0.1uh read at recommended Q meter frequency.
- Inductance below 0.1uh calculated from readings taken at 50MHz.
| Part No. | L min | L nom | L max. | Min Q @ L nom | Color |
|---|---|---|---|---|---|
| 2434-01 | 0.037 | 0.038 | 0.039 | 76 @ 50MHz | Brn |
| 2434-02 | 0.054 | 0.058 | 0.063 | 78 @ 50MHz | Red |
| 2434-03 | 0.080 | 0.085 | 0.090 | 78 @ 50MHz | Orn |
| 2434-04 | 0.100 | 0.110 | 0.120 | 78 @ 50MHz | Yel |
| 2434-05 | 0.120 | 0.135 | 0.150 | 76 @ 50MHz | Grn |
| 2434-06 | 0.142 | 0.163 | 0.184 | 72 @ 50MHz | Blu |
| 2434-07 | 0.174 | 0.192 | 0.216 | 68 @ 50MHz | Vio |
| 2434-08 | 0.200 | 0.224 | 0.248 | 66 @ 50MHz | Gray |
| 2434-09 | 0.234 | 0.260 | 0.284 | 60 @ 50MHz | Wht |
| 2434-10 | 0.260 | 0.288 | 0.315 | 56 @ 50MHz | Blk |
Main Products
coated choke, molded choke, transformer, filter choke, linearity, beads, balun, ceramic chip inductor, SMD power chokes, SMD air wound coils