Before running the engine,read the manual and watch the assembly and engine tuning video that came with this kit.

STARTING THE ENGINE

IMPORTANT! Your radio system must ALWAYS be turned on and the transmitter ansmitter antenna fully extended when running the engine!

1.Fill the fuel tank.

2.Prime the engine-while the engine is cool,place your finger over the tuned pipe's exhaust hole and pull the recoil gently several times.Do not over-prime!Stop when you see fuel in the fuel line at the carb.

3.Install a glow starter(B7004C) into the glow starter ans attach the starter to the glow plug.

4.With the throttle at idle,start the engine by pulling the recoil using short,quick pulls.DO NOT pull the recoil starter's string to the end.You only need 10 to 12 inches of pull to start the engine with the throttle at idle.

Sometimes it is helpful to start the engine at around half throttle.When the engine starts,immediately return the throttle to idle.If this is not done the engine can over-rev and cause engine damage.

IMPORTANT! FIXING A FLOODED ENGINE

If the engine id difficult to turn over with the recoil starter,especially if it is brand new,loosen the glow plow plug a hagf turn before starting the engine.This allows some compression to escape,but the engine will still start.Make sure you tighten difficult to pull,the engine is flooded-there is too much fuel inside the engine.Remove the glow plug,then turn the buggy upside down and pull the recoil 5 or 6 times.This will clear the engine of fuel,and you will notice the recoil pulls easier.Rep;ace the glow plug and repeat the starting procedure.

STOPPING THE ENGINE

Pinch the fuel line that runs to the carburetor.Pinching this line will restrict the fuel flow and the engine will quit within a few seconds.Never place your finger over the exhaust to stop the engine.This could result in serious in serious burns on your finger.It also causes fuel to back up in the engine,making it harder to start the next time you run your car.