FLUIDOFORK can be used for all types of liquids in storage tanks, mixing tanks and pipe lines having:
- Temperature between -20蚓 and +80蚓 (Standard Versions)
- Density greater than 0.7 gm /cm
- Fluidofork is suitable for applications where float switches were previously used and for liquids that are sticky, corrosive, agitated, splashing and foaming. It is widely used in processing plants for liquids having viscosity up to 10,000 cP in Food, Power, Chemical, Sugar, Detergents etc.
Specifications
Probe^$Tuning Fork : Stainless steel - 316
Mounting : 1" BSP screwed (Flanged mounting on request)
Extension : Stainless steel pipe
Probe Length : min 128 mm, max 3000mm
Operating Temperature : -20蚓 to +80蚓
^#Evaluation Unit^$Housing : Cast aluminum, Weather proof, Stoving enamel painted, suitable for back panel / wall mounting.
Cable Entries : 3 Nos. of ?quot; BSP
^#Evaluation Unit^$Mains : 110 or 230 V AC, (?0%), 24V AC/DC
50 Hz. (to be specified while ordering)
Relay Output : One set of potential free change over contact rated at 230V AC, 6A, 50Hz for non-inductive load.
Power consumption : 5 VA approx.
^#Evaluation Unit^$Response Time : 0.5 Sec. typical
Operating Temperature : -20蚓 to + 60蚓
Fail Safe Mode : High or Low field selectable.
^#
Features
No mechanical wear & tear ^$No moving parts so free from maintenance
Operates reliably in viscous liquids
Not affected by streams, turbulences, floating particles and gas bubbles.
Operation is independent of electrical properties.
Can be installed quickly in small entries pipes, and mixing tanks.
Installation is independent of position.
No adjustment required therefore fast commissioning.^#Control function & installation^$Single point control.
Adjustable switching delay for fork covered / uncovered.
Electronics integral with fork.
Electronic remote, wall / back panel mounting
Flame proof versions for hazardous area.
Adjustable insertion length version ^#
Main Products
Level Switch, Detector, Sensor, Transmitter
